Re: Bridge Mode Not Working
Posted by
hans2 on
May 16, 2016; 2:19am
URL: https://itus.accessinnov.com/Bridge-Mode-Not-Working-tp816p908.html
breda wrote
Hi, I did the update again in router mode but sill no internet I also found this on ITUS youtube page not sure if this makes any difference I confused about the Instructions 2. Connect eth0 Shield to local network 3. Connect eth2 Shield to computer used for upgrade but how would I get WAN Traffic?
https://www.youtube.com/watch?v=p-CJmGL7ayQUpgrade Instructions...
1. Put Shield in Router Mode
2. Connect eth0 Shield to local network
3. Connect eth2 Shield to computer used for upgrade
4. Make sure computer behind Shield can access internet
5. Establish SSH Connection to Shield
6. Copy above upgrade script from browser, paste into SSH terminal
7. Wait for firmware download to complete.
8. Reboot Shield
9. Wait 5-10 Minutes
10. Enjoy!
Hi Breda
in router mode, shield will (should) assign IP to a laptop connected.
So step 2 should look like:
a) WAN - modem - ASUS router WAN port
b) ASUS router LAN ports - ETH0/WAN Shield (this should give shield access to internet)
c) ETH2/LAN shield - laptop (this should give your laptop access to shield
http://shield.lan or 10.10.10.10)
make sure that your laptop wifi (to ASUS rotuer) is disabled, to force it to connect via Shield.
In this setup your internet for the other computers should still work, just for the laptop connected to shield it may (not) work.
The wired setup above is how I test shield so that only the wired laptop is impacted by it's functions.
No more: Shield Pro v1, Chaos Calmer, FW 1.51 SP1