Updated Image file

ItusgatewayImage

This update includes:

Fixed Snort 3 init.d scripts to work correctly
Fixed ability to use the Firmware upgrade/update utilities
Added iperf3

Important Notes!

Snort3 can take 2 or 3 minutes to fully load.

If for some reason you experience DNS errors, disconnect and then reconnect the connection to eth0/eth1.  I don't know at this point if the single DNS issue I've seen is due to snort not being started yet.

If you're watching the console, you'll see a final

[  135.579483] device eth0 entered promiscuous mode

This is snort finalizing and starting.   Again, I'm not sure if the single issue I saw was my fault or snorts.

if I can get you all (Turrican, Road, Gnomad) all successfully tested, then I'm going to send out a mass email to the registered accounts here and see if anyone is interested in continuing the use the Shield or not.

I know we talked about needing a Snort luCi page. The one we had won't work at all with Snort3.  The good news is, with the updates, the ability to use more things in making it might help..  For example, not only does it use LUA, but we can use .js pages as well.  If you're interested, check out the Adblock pages under /www/luci-static/resources/view/adblock

Running Itus Shield v2 Firmware

---

If you reply to this email, your message will be added to the discussion below:

http://itus.accessinnov.com/FIRMWARE-Itus-Networks-Shield-Firmware-Upgrade-WIP-tp1726p1991.html

To unsubscribe from [FIRMWARE] Itus Networks Shield Firmware Upgrade *WIP*, click here.
NAML