I have a weird issue with my Shield and I hope I can explain it well enough for someone to understand it and provide a solution. I am currently testing my shield before deploying it on my network.
Shield is in bridge mode.
I have 2 static IPs, I will call them A and B:
Static IP A is my general use internet and surfing
Static IP B is for product testing
I am assuming the eth0 -- > eth2 is the bridge and eth1 is a management port
eth0 is connected to the static IP B router
eth1 is connected to the static IP A network for monitoring and configuring
eth2 is connected to a test laptop
When I log into the shield and check the connection tracking, it is showing the connections from the static IP A network (mainly udp), but not showing any of the connections from the static IP B network.
How do I make the shield ignore the eth1 connections and show only the eth2 connections?