Itus Networks Owners Forum › General Discussion

Help with my Itus Shield

_‹ Previous Topic Next Topic _›

Classic

List

Threaded

3 messages Options

1TUS

Help with my Itus Shield

I have been using the Itus Shield since the beginning. The power supply has gone out but that's about the only problem I have had. Today I noticed that it is not working. I have tried everything from changing the cables to changing the power supply. The unit has power and boots up fine. I am also able to login to the unit through the browser. I am also able to connect to the unit through console cable. I have no idea what is wrong with it. If anyone can point me in the right direction that would be great. Thanks.

Roadrunnere42

Re: Help with my Itus Shield

When you say it's not working in what way ie is it not connection to internet and what version are you using?

Roadrunnere42

On Thu, 30 Jan 2020, 18:33 1TUS [via Itus Networks Owners Forum], <[hidden email]> wrote:

I have been using the Itus Shield since the beginning. The power supply has gone out but that's about the only problem I have had. Today I noticed that it is not working. I have tried everything from changing the cables to changing the power supply. The unit has power and boots up fine. I am also able to login to the unit through the browser. I am also able to connect to the unit through console cable. I have no idea what is wrong with it. If anyone can point me in the right direction that would be great. Thanks.

If you reply to this email, your message will be added to the discussion below:
http://itus.accessinnov.com/Help-with-my-Itus-Shield-tp1920.html

To start a new topic under General Discussion, email [hidden email]
To unsubscribe from Itus Networks Owners Forum, click here.
NAML

1TUS

Re: Help with my Itus Shield

Thanks for the reply. I actually got it to work. I noticed that it would connect to the internet when I used it in router mode so I knew it was not completely broken. I am using it in bridge mode. When I went in to the Network/Interfaces/WAN/Physical Settings page, I noticed that the bridge interfaces was not checked off so I checked it off and added interfaces eth0, eth1, and eth2. After this it started working fine.

I have noticed that since then I have not seen any threats show up in my IPS logs. I usually see one or two per day. Maybe it's too early to tell. I hope I set this correctly. Any advice would be appreciated. I'm still on firmware 1.51 SP1 btw. Thanks.